Filter
Top Products
11
BAS-761
5-4. Bobbin thread winding
1. Pass the bobbin thread from the spool stand as illustrated below.
2. Wind the thread around the bobbin q as arrwed.
3. Press lever w against the bobbin q.
4. After completing bobbin q thread winding, cut the thread.
Note:
Check for any idle rotation of the bobbin q. The motor may overheat, if the bobbin q idles for a long time or if
it rotates without a bobbin. At this time, protector e will go up and the bobbin thread winding motor will not
start. If protector e is pressed after about 20 seconds has elapsed, bobbin theread winding can be restarted.
q
w
e
5. Correct operation