Filter
Top Products
2. Make sure the electrode strips are sufficiently moist.
Moisture enables the electrodes to make proper electrical
contact. Moisten the electrode strips with water, saliva or
Axiom Heartbeat Signal Enhancer. If you are wearing the
transmitter strap over a shirt, make sure the shirt is mois-
tened to provide adequate electrical contact for the elec-
trodes. Accumulated sweat or dirt on the electrode strips
may impair electrical contact. Make sure the electrode
strips are clean.
3. Make sure you have activated the heart rate function
with a long press (press and hold) of the Mode button in
any main screen.
4. Make sure the transmitter battery is installed properly
and fully charged.
What if the heart rate reading becomes
extremely high?
Electromagnetic signals from outside sources may cause
abnormally high heart rate readings. Common sources of
electromagnetic signals are high voltage power lines,
motor driven equipment, and other heart rate monitor
users. Check your surroundings for possible sources of
electromagnetic signals, and move away from the source.
Note: The HR600 automatically records the highest maximum
heart rate attained during a workout. It cannot, however,
distinguish between genuine heart rate signals, and artifi-
cially high heart rate signals caused by electrical interfer-
ence. For this reason, the HR600 may occasionally record an
artificially high maximum heart rate caused by electrical
interference encountered during a workout.
46 47