Filter
Top Products
Groundsmaster 4000--D Cutting DecksPage 8 -- 3
General Information
CAUTION
Never install or work on the cutting decks or lift
arms with the engine running. Always stop en-
gine and remove key first.
Operator’s Manual
The Operator’s Manual provides information regarding
the operation, general maintenance and maintenance
intervals for your Groundsmaster machine.Refer to that
publication for additional information when servicing
and adjusting the cutting decksonyourGroundsmaster.
Castor Wheel Tire Pressure
Castor tires on the front and side decks should be in-
flated to 50 PSI (345 kPa).
Blade Stopping Time
The blades of the cutting deck are to come to a complete
stop in approximately five (5) seconds after the cutting
deck engagement switch is shut down.
NOTE: Make sure the decks are lowered onto a clean
section of turf or hard surface to avoid dust and debris.
To verify this stopping time, have asecondperson stand
back from the deck at least 20 feet and watch the blades
on one of the cutting decks. Have the operator shut the
cutting decks down and record the time it takes for the
blades to come to a complete stop. If this time is greater
than 7 seconds, the braking valve on the hydraulic man-
ifold may need adjustment.
Cutting Decks