Filter
Top Products
Groundsmaster 4000--DPage 5 -- 10Electrical System
Fuses
The fuse blocks are located under the operator control
panel.
Identification, Function and Wiring
The fuses are held in three (3) fuse blocks. Use Figures
9 and 10 to identify each individual fuse and its correct
amperage. Each fuse has the following functions.
FuseF1(5amp)(fuseblocklocation A1): Supplies
power to the seat switch and seat relay.
Fuse F2 (10 amp) (fuseblock location A2): Sup-
plies power to ignition switch terminal B.
Fuse F3 (10 amp) (fuseblock location A3): Sup-
plies power to the PTO switch.
Fuse F4 (10 amp) (fuseblock location A4): Sup-
plies power to the starter solenoid.
Fuse F5 (when optional lighting is installed) (15
amp) (fuseblock location B4): Supplies power for
optional light kit.
Fuse F8 (10 amp) (fuseblock location B1): Sup-
plies power to the power point outlet.
Fuse F9 (7.5 amp) (fuseblock location C4): Sup-
plies power for engine cooling fan operation
(TEC--5002 controller).
Fuse F10 (10 amp) (fuseblock location C3): Sup-
plies power for seat operation.
In addition to the fuses in the fuse blocks, a 2 amp fuse
is included in the wire harness to protect the logic power
circuit for the TEC--5002 controller. This fuse resides in
a fuse holder near the battery.
Figure 9
A
B
1234
C
10A5A
10A
10A
10A
OPT
15A
10A
7.5A
Figure 10