Filter
Top Products
Installing the Console 47
4. Line up the two small tabs at the bottom of the console’s
back cover with the slots at the bottom of the console
case. Insert the tabs into the slots.
5. Insert the two #8–32 x ¹₂-inch Phillips-head screws that
you removed earlier into the holes at the top edge of the
console’s back cover. Tighten the screws fully.
Important: Use caution not to pinch the cables between the
back cover and PVS mounting screw heads.
6. Fully tighten the four mounting screws (partially
tightened in step 3) using a ⁵₃₂-inch hex wrench.
Reassembling the Treadmill Fairing
After the console is in place, reattach the two cover panels of
the treadmill fairing.
Important: In the following procedure, do not allow the fasteners
to break or pinch any cables.
To reassemble the fairing:
1. Verify that the cable assembly is secure inside the cable
clips and that the ferrite bead on the base unit data cable
is tied securely into place in the left arm of the treadmill.
2. Snap the rear cover into place and attach the seven
screws you removed with it earlier.
Figure 27: Removal and replacement of the rear fairing cover