Filter
Top Products
18 Assembling and Maintaining TRM 800-Series Treadmills
5. Remove the shipping fasteners from the front panel using
a ¹₄-inch hex key and a ¹⁄₂–inch box-end wrench.
6. Remove any tape or wire ties securing the console cable
to the side of the unit.
Before you begin, verify that you have received the following
parts:
Base frame assembly
Left and right upright supports
Center fairing with handrails
Hardware kit
Installation Requirements
The location where the treadmill is installed must provide
power connections that supply the appropriate voltage, a 20A
individual branch circuit, and grounding per NEC (National
Electric Code) guidelines or local region electric code.
CAUTION: Do not use a non-grounded outlet or transformer. Do
not remove or otherwise bypass the plug with an adapter.
Electrical damage can occur and void the Precor Limited Warranty
if the treadmill is connected to an improper power source.
Required Tools
¹₄-inch hex wrench
⁵₃₂-inch hex wrench (ball end is desirable)
¹₂-inch box-end wrench
Bubble level
#2 Phillips screwdriver
String or fish tape
Wire cutter