Filter
Top Products
46 Assembling and Maintaining TRM 800-Series Treadmills
Table 3. P30 and P10 internal cable connections
Cable Connector Type Circuit
Connector
Location
Safety key (treadmills
only)
Six-contact strip, keyed
Automatic stop sensor
(treadmills only)
Four-contact strip,
keyed
Data from base unit Eight-contact modular,
on flat gray cable
Heart rate sensors
Four-contact strip,
keyed
CSAFE Eight-contact modular,
on flat gray cable
Completing the Console Installation
(P30 and P10)
Before you complete the final installation steps, double-check
the connections you have made. Make sure that all cables are
fully and securely connected, and that any unneeded cables
are tied back properly.
To complete the installation:
1. Feed extra cable back into the neck tube.
2. Tilt the control console backward (toward yourself) until
the tab on the top edge of its back plate slides along the
top edge of the console mount and the screw holes align
properly.
3. Insert the four ⁵₈-inch flat head screws through the holes
in the console mount and thread them into the holes in
the back plate on the console. Partially tighten the screws
using a ⁵₃₂-inch hex wrench.