Filter
Top Products
Assembling the Treadmill 21
3. Remove the seven screws holding the back cover in place.
Snap the back cover loose and set it aside, along with the
seven screws.
Figure 4: Removal and replacement of the rear fairing cover
4. Remove the two ends of the base unit data cable from the
left arm of the fairing (position 1 in the following
illustration). Route the shorter of the two cable ends into
the fairing and extend the long end outward.
Figure 5: Cable storage locations in the treadmill fairing: base
unit data cable (1) and Auto Stop cable (2)