Filter
Top Products
32 Operating and Maintaining the P10 Console
Using the Treadmill Safety Clip
The treadmill is equipped with two different stop functions,
which behave as follows:
If the user … Then the
treadmill belt …
And the console …
Pulls on the lanyard
attached to the safety
clip and trips the
restart switch.
Slows to a stop. Shows the words PUSH
TO RESET SWITCH. On
some console models, an
arrow points toward the
Restart switch.
Presses down on the
red STOP button.
Slows to a stop. Shows that the exercise
workout is paused.
The restart switch is located just below the console and
immediately behind the red STOP button, as shown in the
following figure. When it is tripped, the bar pops up,
displaying the words PUSH TO RESET on its front side. The
treadmill does not operate while these words are visible.
Figure 6: Restart switch
Instruct users on how important it is to use the safety clip
while exercising on the treadmill, and demonstrate how they
should attach it to their clothing near the waistline.