Filter
Top Products
Installing the Console 37
Table 2. P80 internal cable connections
Cable Connector Type Circuit
Connector
Location
Ethernet (LAN) Eight-contact modular,
on round black cable
TV in F-type coaxial
Power Two-contact plug,
polarized and latched
Data from base unit Eight-contact modular,
on flat gray cable
Heart rate sensors Four-contact strip, keyed
Safety key (treadmills
only)
Six-contact strip, keyed
CSAFE Eight-contact modular,
on flat gray cable
Automatic stop
sensor (treadmills
only)
Vertical four-contact
strip, keyed
To simplify installation and maintenance, route and connect
cables 1 through 5 according to the following instructions.
Note: In the illustrations in this section, some cables are
omitted for the sake of clarity.
Connecting the Television Cable
The console’s television tuner is mounted inside the console’s
back plate. The tuner includes a short cable adapter that
allows the television cable to be connected outside the back
plate.
To connect the television cable:
1. Pull the cable out through the lower right corner of the
back plate.
2. Route the cable counterclockwise around the outside of
the back plate.
Important: In the following step, install the cable using a
torque wrench and torque not to exceed 8 lb-in. If a torque
wrench is not available, install the coaxial cable using a plain
wrench and tighten to "snug +
¹₄
turn." You may also use a
wrench on the internal nut to help tighten the connection.