Filter
Top Products
page 17
Diagram 13
Adjust
the rear
foot.
Important: If you need to make adjustments, adjust one rear foot at a time. Do
not use the rear foot to raise or lower the unit more than 1/4” in height. Check
the level of the unit after each adjustment.
15. To adjust a rear foot, locate the nut that secures the rear foot to the deck. See
Diagram 13. Loosen the nut with a crescent wrench or appropriate open-end
wrench until you can easily turn the foot. See inset in Diagram 13.
16. To raise the rear deck, turn the foot clockwise and make the proper height
adjustment. Then, retighten (counterclockwise) the nut securely using the
wrench.
Turning the Unit ON and OFF
Use the ON/OFF (I/O) power switch to turn the unit ON and OFF. This switch is
located on the front of the unit, near the power cord.
The treadmill requires a dedicated circuit. Plug the power cord into a dedicated
20 amp, grounded, power source. Make sure that no other product or machine
uses the same circuit as the treadmill.
To complete the installation of the treadmill, continue to
Checking the Alignment of the
Running Belt
on the next page
.
CAUTION: Ask for assistance to lift the
rear of the unit slightly off the floor. Lift
the unit by its side rails. Trying to lift the
unit and adjust the rear foot without
assistance may cause injury to yourself
or damage to the unit. Do not try to lift the
unit using the running belt.
CAUTION: Never remove or bypass the
3-prong plug on the unit’s power cord with
an adapter. Do not use a non-grounded
outlet. Do not plug the treadmill into a
power transformer in an attempt to adjust
the voltage requirements.