Filter
Top Products
page 16
3
Slide the
hood under
the 2 screws
found on the
inboard side
of both
upright
supports.
4
Diagram 11
Secure the
hood.
2
1
13. Attach the hood. Diagram 11. Place the hood over the motor and slide it
under
the upper 4 screws (see Diagram 11 #1) and
over
the 2 lower screws (1 found
on each side) of both upright supports.
As you lower the hood, slide the hood under the washers and onto the screws (2 in
the front, 1 on either side of the treadmill). See Diagram 11, #2 and #3. Retighten the
screws that you loosened in step 4.
Be sure that the hood is sandwiched be-
tween the base assembly and the washers. The washers must be on the
outside of the hood.
Tighten the screws securely using the hex key provided.
21
Diagram 12
Level
the
unit.
14. The M9.55 has adjustable rear feet. Check to make sure that the running surface
is level (use a bubble level as shown in Diagram 12). If the treadmill is placed on
a slightly, uneven surface, adjusting the rear feet can help, but will not compen-
sate for extremely uneven surfaces.
CAUTION: Do not overtighten the screws
or you may inadvertently cause stress
cracks in the plastic hood.