Filter
Top Products
page 14
Diagram 7
Attach the
console to the left
upright support.
10. Secure the display console to the left upright support. Diagram 7. Align the
mounting holes on the console to those on the left upright support. Insert 2
screws (A) and washers (B). Do not securely tighten the screws until after the
handrails have been attached.
Important: With the handrails attached, the width of the treadmill is 36.75”
(93 cm). It will not fit through a standard 36” doorway.
Buttonhead screws
1
3
2
Console
extension
Diagram 8
Handrail alignment and installation.
11. Attach the handrails. Diagrams 8 and 9. For ease of assembly, place the side
rails or rear feet on blocks. Obtain assistance to lift the treadmill. Do not place
blocks beneath the running bed.
To attach the handrails, perform the following steps on
one side at a time
:
a. Alignment pins on the top of the handrails necessitate sliding the handrails into
the console assembly at an approximate 45
o
angle. Position the handrail as
shown in Diagram 8 and slide it onto the console extension. When the alignment
pins are fully engaged, carefully lower the handrail toward the base. Place as
washer (D) on each of 2 screws (C). Insert the screws and finger-tighten.