Filter
Top Products
532i Elliptical Fitness CrossTrainer Assembly Guide 7
Prepare the stabilizers for installation. Use a ⁵₃₂-inch hex key
to loosen the two clamp fasteners.
Thread a leveler (L) onto each stabilizer.
Note: Make sure the nut is fully threaded onto the leveler.
Refer to the illustration.
For easier access to the base mounts, lift the front of the EFX
off the floor and place a wedge of packaging beneath its
base.
Install the stabilizer with the cable protruding from both ends.
This requires coordinating efforts. Read through the following
two steps before proceeding.
1. Ask your assistant to connect the base cable while you
hold the stabilizer close to the frame. An audible click is
heard when the cable is properly attached. Place any
excess cable inside the base frame.
2. While the cable is being attached, you need to place the
stabilizer onto the metal shaft and engage the clamp.
Wrench tighten the two fasteners in the clamp. Rotate and
slide the shaft cover so the tabs rest on the heads of the
two fasteners. Apply pressure to secure the shaft cover in
place.
Secure the stabilizer to the base frame using four hex head
screws (A), four split washers (E) and four washers (B).
Finger tighten.
Note: The split washers should be sandwiched between the
head of the screw and the flat washers. Also, if you encounter
difficulty aligning the base mounts, check the height of the
levelers and adjust them accordingly.
Attach the opposite stabilizer to the metal shaft and wrench
tighten the clamp. Rotate the shaft cover so the tabs rest on
the heads of the two fasteners. Apply pressure to secure the
shaft cover in place. Secure the stabilizer to the base frame
using four hex head screws (A), four split washers (E), and
four washers (B). Finger tighten.