Filter
Top Products
532i Elliptical Fitness CrossTrainer Assembly Guide 1
Thank you for choosing Precor. For proper installation, please read this
guide thoroughly and follow the assembly instructions. If you do not
assemble the EFX according to these guidelines, you could void the Precor
Limited Warranty.
Obtaining Service
You should not attempt to service the EFX except for maintenance tasks
described in the owner’s manual. Should you need more information
regarding Customer Support numbers or a list of Precor authorized Service
Centers, visit the Precor web site at www.precor.com/corp/contact.
Unpacking the Equipment
The EFX is carefully tested and inspected before shipment. The unit is
shipped in one box. Ask for help from two or more people to unpack and
assemble the EFX. If any items are missing, contact your dealer.
Required Tools
• ½-inch Socket wrench with extension
• ⁹⁄₁₆-inch Socket wrench
• Crescent wrench
• Wire cutter
• Standard set of hex keys
• Long-handle ⁵⁄₃₂-inch hex key
• Phillips-head screwdriver
Cardio Theater PVS Assembly
Instructions
If the Cardio Theater Personal Viewing System (PVS) accompanies this
Precor product, review the PVS assembly instructions found in the Cardio
Theater box. Alleviate additional assembly or disassembly steps by
combining the two assemblies as needed.
Installation Requirements
Follow these installation requirements when assembling the unit:
• Assemble the unit near the location where you plan to use it
because it is heavy.
• Provide ample space around the unit.
Open space around the unit allows for easier access.
• Set up the unit on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level. A level unit has
fewer malfunctions.
• Open the box and assemble the components in the sequence
presented in this guide.
• Obtain assistance.
Ask another capable adult for assistance during the assembly process.
• Use your fingers or the appropriate tools to insert fasteners.
Proper alignment helps alleviate cross-threading. Do not fully wrench
tighten fasteners until instructed to do so.
When wrench tightening, the head of the fastener should be flush with
the product. If it is not, cross-threading has occurred. Do not attempt to
rework the assembly as more damage to the equipment will occur.
Contact Customer Support. Refer to Obtaining Service.