Filter
Top Products
Selecting a U.S. Standard or Metric
Display
The equipment can display measurements in either Metric or U.S.
Standard. The default factory setting is to display U.S. Standard. To
change this setting, perform the following steps:
1.
2.
1.
2.
At the
SELECT UNITS
prompt, press OK. Use the navigational
arrow keys to select a unit of measure (
US
or
METRIC
).
CAUTION: If you change the Unit of Measure display on a
treadmill, be sure to check the speed setting to verify that it is
correct. Refer to Treadmill: Determining the Club Speed
Limit.
When you are ready, press OK to accept the displayed setting
and move to the next feature. For other options, refer to the table
in Accessing Club Programming Mode and Changing the
Settings.
Setting an Exercise Session Time Limit
You can limit how long a user can exercise on the equipment. For
example, if you set the time limit to 20 minutes, users can only enter
a session time between 1 and 20 minutes.
Note: The automatic cool-down period is appended to the end of
any time-based program, so adjust the time limit accordingly.
You can also let a user exercise indefinitely by selecting
NO LIMIT
.
However, you will need to instruct the users that once they select a
program and the workout time appears in the display, they need to
use the Number Keypad to type in 240. They must then press the
up arrow key to display
NO LIMIT
, and press OK.
The exercise session times available are between 1 and 240
minutes.
At the
SET MAX WORKOUT TIME
prompt, press OK. Use the
navigational arrow keys to change the displayed time limit.
Note: When you press and hold a navigational arrow key, the
number increments by five, for example, 1, 5, 10, 15, 20. When
you tap an arrow key, the number increments by one.
When you are ready, press OK to accept the displayed setting
and move to the next feature. For other options, refer to the table
in Accessing Club Programming Mode and Changing the
Settings.
Product Owner's Manual: Club Features 20