Filter
Top Products
Polar s3 Stride Sensor W.I.N.D.
To activate the stride sensor in your training computer, select Settings > Features > Shoes/bikes > Shoe
1/2/3 > On. Teach new sensor? is displayed.
• If your sensor is already taught, select No.
• If your sensor has not been taught yet, select Yes.
Before teaching, make sure that there are no other s3 stride sensors or G3 GPS sensors nearby (40 m/131
ft). The sensor should be within 1,5 meters/5 ft of the training computer. Before entering a running event,
for example, make sure to perform the teaching process at home, first. This is to prevent interference due
to the long-range data transmission.
To return to time mode, press and hold the STOP button.
Polar Cycling Speed Sensor W.I.N.D.
To activate the speed sensor in your training computer, select Settings > Features > Shoes/bikes > Bike
1/2/3 > On > Speed > On. Teach new sensor? is displayed.
• If your sensor is already taught, select No.
• To teach a new sensor, make sure that there are no other speed sensors nearby (40 m/131 ft) and
then select Yes.
After selecting Yes, rotate the wheel a few times to activate the sensor. The flashing red light
indicates that the sensor is activated. Completed is displayed once the teaching process is over. The
training computer is now ready to receive speed and distance data.
To return to time mode, press and hold the STOP button.
Polar Cadence Sensor W.I.N.D.
To activate the cadence sensor in your training computer, select Settings > Features > Shoes/bikes > Bike
1/2/3 > On > Cadence > On. Teach new sensor? is displayed.
• If your sensor is already taught, select No.
• To teach a new sensor, make sure that there are no other cadence sensors nearby (40 m/131 ft)
and then select Yes.
After selecting Yes, Start test drive is displayed. Rotate the crank a few times to activate the sensor.
The flashing red light indicates that the sensor is activated. Completed is displayed after the
teaching has been finished. The training computer is now ready to receive cadence data.
To return to time mode, press and hold the STOP button.
Polar G3 GPS Sensor W.I.N.D.
To activate the G3 GPS sensor in your training computer, select Settings > Features > G3 > On. Teach new
sensor? is displayed.
• If your sensor is already taught, select No.
• To teach a new sensor, make sure that there are no other s3 stride sensors or G3 GPS sensors
nearby (40 m/131 ft) and then select Yes.
To return to time mode, press and hold the STOP button.
Altitude
The training computer converts measured air pressure into an altitude reading. Change the settings of
Polar RS800CX User Manual 28