Filter
Top Products
44
FIGURE 55
ADJUSTMENT
• Adjustments can be made in the above locations to set the correct amount of tension in the cables.
STEP 55:
51
16
• If upon completion of assembly, the HEAD PLATE (51) does not sit on top of the first WEIGHT PLATE (115), push the HEAD
PLATE (51) down, insert the WEIGHT STACK PIN (62) and perform several repetitions. This will relax the cable system and
prevent the HEAD PLATE (51) from lifting up. See FIGURE 55.
• If after completing the previous step, the HEAD PLATE (51) still does not sit on top of the first WEIGHT PLATE (115) or if
there is excess slack in the cable system, adjust the threaded ends of the CABLES attached to the FLOATING PULLEY BRACKET
(16) and the THREAD HOUSING (118) accordingly and retighten the jam nuts. See figure 55.
• For maximum performance, the HEAD PLATE (51) should just barely sit on the top WEIGHT PLATE (115).
Thank you for purchasing the ParaBody 880 Gym System. If unsure of proper use of equipment, call
your local ParaBody distributor or call the ParaBody customer service department at (800) 328-9714
• NOTE: After making adjustments make sure all jam nuts are SECURELY TIGHTENED!
• This completes the assembly of the 880 Gym System. If the 880 SHROUD OPTION was purchased refer to the 880 SHROUD
KIT assembly instructions.
115
62
ADJUSTMENT
ADJUSTMENT
118
ADJUSTMENT