Filter
Top Products
28
FIGURE 30
STEP 31:
FIGURE 31
STEP 30:
• Assemble the BACK PAD SUPPORT (26) to the BENCH ROCKER (27) using two 1/2 X 6” BOLTS (97) and two 1/2” LOW
HEIGHT LOCK NUTS (85). (Note: Tighten this connection enough to remove excess play yet allow the BENCH
ROCKER to rotate freely.)
• SECURELY assemble the BENCH SEAT PAD (29) to the HINGE TABS (111) using two 3/8 X 1” BOLTS (87) and two 3/8”
WASHERS (80). See FIGURE 31.
• SECURELY assemble the BENCH BACK PAD (31) to the BENCH BRACKET (30) and the BACK PAD SUPPORT (26) using two
3/8 X 2-3/4” BOLTS (90) and two 3/8” WASHERS (80). See FIGURE 31.
111
80
30
80
26
31
111
28
85
26
27
3/8 X 2-3/4” 90
3/8 X 1” 87
1/2 X 6” 97
• Assemble two HINGE TABS (111) to the tubes on the BENCH SEAT ADJUST (28) as shown in FIGURE 30.
29