Filter
Top Products
FIGURE 21
21
STEP 21:
• SECURELY assemble the PRESS ARM (38) to the PRESS PIVOT (35) using two 3/8 X 3” BOLTS (91) four 3/8” WASHERS (80)
and two 3/8” LOCK NUTS (82) as shown in FIGURE 21.
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
86
81
91 3/8 X 3”
53
85
39
82
38
35
80
40
• Assemble the RIGHT PRESS HANDLE (39) to the PRESS ARM (38) using two 3/4” FLANGE BEARINGS (53), one 1/2” WASHER
(81), one 5/16” ROLL PIN (86) and one 1/2” LOW HEIGHT LOCK NUT (85) as shown in FIGURE 21. (NOTE: Tighten 1/2”
LOW HEIGHT LOCK NUT (85) to remove excess play yet allow the RIGHT PRESS HANDLE (39) to rotate freely.)
• Assemble the LEFT PRESS HANDLE (40) to the PRESS ARM (38) using two 3/4” FLANGE BEARINGS (53), one 1/2” WASHER
(81), one 5/16” ROLL PIN (86) and one 1/2” LOW HEIGHT LOCK NUT (85) as shown in FIGURE 21. (NOTE: Tighten 1/2”
LOW HEIGHT LOCK NUT (85) to remove excess play yet allow the LEFT PRESS HANDLE (40) to rotate freely.)
8)
• Insert the PUSH-PULL CABLE (122) into the slot of the RIGHT PRESS HANDLE (39) and through the tube as shown in
FIGURE 21.
122