Filter
Top Products
30
STEP 33:
FIGURE 33
• Assemble two 3-1/2” PULLEYS (44) to the
BOOM BRACKET (8) using two 3/8 X 1-3/4”
BOLTS (88) and two 3/8” LOW HEIGHT LOCK
NUTS (83) as shown in FIGURE 33.
• Screw the long threaded end of the WEIGHT
STACK CABLE (48) into the end of the HEAD
PLATE (51) .See FIGURE 33.
• Route the WEIGHT STACK CABLE (48) around
the pulleys in the BOOM BRACKET (8) as shown
in FIGURE 33. (NOTE: Make sure the cable
runs in the grooves of the pulleys.)
• Assemble the WEIGHT STACK PIN (62) to the
HEAD PLATE (51) as shown in FIGURE 33.
• IMPORTANT! Uncoil and straighten all
CABLES in order to remove all twist prior to
installation
8
44
83
62
48
51
88 3/8 X 1-3/4”
STEP 32:
FIGURE 32
• Route the WEIGHT STACK CABLE (48) around one 3-1/2” PULLEY (44) and assemble two PULLEY PLATES (7) to the 3-1/2”
PULLEY (44) using one 3/8 X 1-3/4” BOLT (88) and one 3/8” LOCK NUT (82). See FIGURE 32.
3/8 X 1-3/4” 88
7
48
44
82