Filter
Top Products
16
STEP 11:
• SECURELY assemble one PEC STATION PAD (3) to the SEAT ADJUST (4) using two 3/8 X 1-3/4” BOLTS (88) and two 3/8”
WASHERS (80). See FIGURE 11.
FIGURE 11
3/8 X 1-3/4” 88
80
4
3
STEP 12:
• Securely assemble one 10/32” SET SCREW (101) to the plunger pin barrel on the FRAME (1) then back off 1/4 turn so
PLUNGER PIN (77) rotates freely.
• Apply eight PARAGLIDES (73) to the INSIDE of the tube on the FRAME (1) and on the OUTSIDE of the SEAT ADJUST (4) as
shown.
• CAREFULLY insert the SEAT ADJUST ASSEMBLY into the FRAME (1) as shown. The SEAT height can be adjusted using the
PLUNGER PIN (77).
77
1
73
4
101
• Securely assemble one PLUNGER PIN (77) to the FRAME (1) as shown. (NOTE: Screw PLUNGER PIN (77) in all the way.)
FIGURE 12