Filter
Top Products
EC-1200 EC-1600 EC-3600 EC-3700
Applicable Models:
Cateye Ergociser Series 1000 Service Manual
49
MS-12
MS-12
Replacing the Inner Pipe Spacer
REMOVAL
1. Slide the seat pipe to the utmost back end, and set it at a posi-
tion where the screw head can bee seen through the hole on
the top surface of the seat pipe.
2. Remove the stopper screw. (Fig. 1)
3. Pull out the seat pipe and the inner pipe spacer A, while
depressing the two bosses, located at the right and left sides of
the seat pipe, at the same time. (Fig. 2)
4. Remove the spacer B at the end of the inner pipe. (Fig. 3)
ASSEMBLING
1. Set a brandnew inner pipe spacer B into the seat pipe. (Fig. 4)
2. Insert the inner pipe spacer A and B together into the seat pipe.
3. Align the hole on the top surface of the seat pipe with the screw
hole, and apply the stopper screw. (Fig. 1)
Fig. 1
Stopper Screw
Inner Pipe
Seat Pipe
Fig. 2
Inner Pipe Spacer A
Pull out.
Inner Pipe
Boss
Fig. 3
Inner Pipe
Inner Pipe Spacer B
Fig. 4
Inner Pipe Spacer A
Inner Pipe Spacer B
Insert.
Inner Pipe
Seat Pipe
Replacing the Inner Pipe Spacer