Filter
Top Products
Cateye Ergociser Series 1000 Service Manual
47
EC-1200 EC-1600 EC-3600 EC-3700
Applicable Models:
MS-10
MS-10
Fig. 1
Replacing the Post Spacer
REMOVAL
1. Remove the center cover, by referring to the Section MS-19
"Replacing the Center Cover of Upright Type."
2. Remove the lock nut located at the side of the frame, and then
remove the adjust screw. (Fig. 1)
3. Pull out the spacer spring. (Fig. 1)
4. The post spacer can be pulled out upward while the boss at
the side of the post is being pressed in with a screwdriver (for
both right and left sides). (Fig. 2)
ASSEMBLING
1. Insert a brandnew post spacer.
2. Insert the spacer spring, and slightly fasten the adjust screw.
(Fig. 3)
3. Insert the seat post (handleber post), and adjust the adjust
screw so that the post will drop slowly.
4. Fasten the lock nut to lock the adjust screw.
5. Assemble the center cover, by referring to the Section MS-19
"Replacing the Center Cover of Upright Type."
Spacer Spring
Adjust Screw
Lock Nut
Fig. 2
Post Spacer
Boss
Press in.
Fig. 3
Lock Nut
Adjust Screw
Replacing the Post Spacer