g
To remove the Test Pattern, press the [Esc] button on the remote
control or the control panel.
Adjusting the Volume
You can adjust the volume using one of the following methods.
• Press the [Volume] buttons on the remote control to adjust the volume.
[
a] Decreases the volume.
[
b] Increases the volume.
Remote control
• Adjust the volume from the Configuration menu.
s Settings - Volume p.178
Caution
Do not start when the volume is set too high.
A sudden increase in volume may cause loss of hearing. Always lower the
volume before powering off, so that you can power on and then gradually
increase the volume.
Adjusting the Image
Hue, Saturation, and Brightness Adjustment
You can adjust the Hue, Saturation, and Brightness for each of the R (red),
G (green), B (blue), C (cyan), M (magenta) and Y (yellow) color
components.
This item can only be adjusted when Color Mode is set to Customized.
s "Selecting the Projection Quality (Selecting Color Mode)" p.67
Make settings from the configuration menu.
s
Image - Advanced - RGBCMY p.175
Hue Adjusts the overall hue of the image, bluish - greenish - reddish.
Saturation Adjusts the overall vividness of the image.
Brightness Adjusts the overall color brightness of the image.
Gamma Adjustment
You can correct differences in the coloring for the projected image that
occurs depending on the connected device.
This item can only be adjusted when Color Mode is set to DICOM SIM or
Customized.
s "Selecting the Projection Quality (Selecting Color Mode)" p.67
Adjusting Projected Images
66
