D
Temp indicator Indicates the internal temperature status.
Indicators Status Explanation
Power supply Status
Blue - Lit Off
Standby condition Power is being supplied to the projector. When the [t] power button is pressed in this condition, projection
starts.
Network monitoring
status
The projector is being monitored and controlled over a network (when Standby Mode is set to
Communication On). If the power cord is disconnected and then reconnected in this status, the power
indicator flashes blue.
Blue - Lit Blue - Flashing
Warm-up status This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds after
the lamp turns on. In this status you cannot turn off the projector, even if you press the [t] power button.
Cool down status This is the status immediately after turning off the projector. In this status, all buttons are disabled.
Blue - Lit Blue - Lit
Normal status The projector is projecting.
See the following table for the status of indicators and how to resolve the problems.
If all indicators are off, check that the power cord is connected correctly and that the power is being supplied normally.
Sometimes, when the power cord is unplugged, the [
t] power indicator remains lit for a short period, but this is not a fault.
Indicators Cause Remedy or Status
Power sup‐
ply
Status Lamp Temp
Off Blue - Flash‐
ing
Orange -
Flashing
Off
Internal Error Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Off Blue - Flash‐
ing
Off Orange -
Flashing
Fan Error
Sensor Error
Stop using the projector, remove the power plug from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Problem Solving
206
