Indicators Cause Remedy or Status
Power sup‐
ply
Status Lamp Temp
Off Blue - Flash‐
ing
Off Orange - Lit
High Temp Error
(Overheating)
The lamp turns off automatically and projection stops. Wait for approximately five minutes. After
approximately five minutes the projector switches to standby mode, so check the following two
points.
• Check that the air filter and air exhaust vent are not blocked, and that the projector is not positioned
against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.231, "Replacing the Air Filter" p.238
If the error continues after checking the points above, stop using the projector, remove the power
plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
sExtended - Operation - High Altitude Mode p.179
Off Blue - Flash‐
ing
Orange - Lit Off
Lamp Error
Lamp Failure
Check the following two points.
• Take out the lamp and check whether it is cracked.
s "Replacing the Lamp" p.234
• Clean the air filter.
s "Cleaning the Air Filter" p.231
If the lamp is not cracked: Reinstall the lamp and plug in the power cord.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
If it is cracked: Contact your local dealer or the nearest address provided in the Epson Projector
Contact List. (Images cannot be projected until the lamp is replaced.)
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
sExtended - Operation - High Altitude Mode p.179
Lamp Cover Open Check that the lamp and lamp cover are securely installed.
If the lamp or the lamp cover are not installed correctly, the lamp does not turn on.
s "Replacing the Lamp" p.234
Problem Solving
207
