6. GUI orientation
6.15 Configuration Menu > Adjustment > Out put Configuration
General
In the Output m enu users can assign output connectors to configurations and adjust signal param eters to match the display devices
connected to the unit
Output Card arrangement
Output cards occupy slots 11 through 12 and right justified to slot 13. If we hav e an empty output slot, all output cards to the left of
that empty slot will be red. Red indicates that although the cards will operate properly, outputs from these cards will not be available
at the multiviewer
Image 6-22
If the card with the connectors that are part of an output configuration is missing, the card in the E2 graphic and the output configu-
ration in the configuration list will be grayed out.
Also, if there is an existing output configuration but the card in the s lot is of different type, then again the configuration will be greyed
out.
Output Connector Grouping
The c onnectors can also be grouped together to defi nea3Dof4Kconfiguration. For example, a projector that requires 2 DVI
connectors to pass 3D Left and Right eye signals. A lso 4 SDI connectors can be configured as a 4K output in order to connect to a
4K projector
There ar e several rules that apply when defining an output configuration:
1. One Output connector can only be assigned to one output configura tion.
2. Outputs in an output configuration must be of the same type AND in the same s lot or in adjacent slots. For example, cannot
have a HDMI c onnector and an SDI c onnector in the same output configuration.
3. Max connectors for an output configuration = 4.
4. Once output c onnectors are assigned to the same output configuration, all settings for the output connectors will be synchro-
nized.
5. If an output connector is not assigned to an output configuration,
- O utput settings cannot be adjusted on that connector.
- The connector cannot be assigned to a destination
Examples of 4K Valid Inputs:
Image 6-23
Examples of valid 3D Inputs:
92
R5905948 E2 12/12/2014
