7. System Setup
7.16 Configuration Menu > Add MVR Out puts
General
In this procedure, you will add MVR O utputs to the system.
Prerequisite
• Ensure that you are familiar with the Configuration Menu. For details on this menu, please refer to chapter "Configuration
Menu", page 76
If more than one Outpu t is u tilized, repeat the b elow steps until all outputs are added and adjusted .
Add MVR Output
1. Click on the MRV tab to s elect the outputs that will be defined.
2. Click on the +Add MVR Output blue button to enter the Add mode.
3. Click on the connector that the input signal is connected to define it as an output.
4. Click on the Done Adding button to exit the A dd mode.
(Optional) Edit the Name
1. Double click on default name in the Name list to edit the name.
2. When the area turns blue, click t he eraser icon to clear the field.
3. Type a new name and hit enter when done.
(Optional) Adjust Output Parameters
Click on the “Adjust” tab that is located on the top. F rom this menu you can adjust:
1. Edit the name.
2. Select Format v alue, color space and connector type.
3. Enable Test Patterns with raster box and enable diagonal motion.
4. Define the Area of interest (AOI).
5. Perform color adjustments.
6. Read the timing parameters associated with the selected format.
7. Adjust HDMI parameters.
(Optional) Auto create MVR Outputs
If the Auto create MVR Outputs is pressed, then the software will add a ll unassigned outputs to the output list and number them
sequentially.
(Optional) Delete Outputs
1. Click on the blue button Delete MRV Output(s).
2. From the Name list click o n the “x” space next to the O utput(s) you w ish to delete.
3. Hit the red button D elete Output( s) button. All o f the selected Outputs will be removed from the list.
R5905948 E2 12/12/2014
173
