7. System Setup
7.1 Setup Prerequisites
Prerequisites
Before s tarting to set up your E2 system, please review the following prerequisites:
• Ensure that you are familiar with front panel menus and EM GUI software.
- For details on all menus, please refer to chapter "F ront Panel Menu orientation", page 45.
- For details on EM GUI, please refer to chapter "GUI orientation", page 67.
• Ensure that you are familiar with the E2 sy stem, including system c ontrol m eans and features. For details, please r efer to
Chapter "General", page 13.
• Ensure that the unit is physically secured on a rack or is placed on a flat surface with a stable support. If the unit is installed on
a rack, it is m andatory that the rear b rackets are also installed. For details, please refer to chapter "E2 Rack-Mount P rocedure",
page 25.
• Ensure that all hardware is properly installed, and that all sources, displays and peripherals are properly connected. For details
concerning E2 connectors, please refer to the unit rear panel description in the ch apter "Rear panel", page 32.
• Connect the AC power to the unit. If power redundancy is des ired, connec t power to both power p lugs.
• Make sure that the E2 is connected to the Ethernet local network in order to communicate with the PC where the control software
is installed.
158
R5905948 E2 12/12/2014
