7. System Setup
7.9 Backing up the system
General
In this procedure, you will back up your system configuration to a USB drive.
Prerequisite
• Ensure that you ar e familiar with the USB device (Backup/Restore) M enu. F or details on this menu, please refer to c hapter
"System menu > USB device (B ackup/Restore)", page 54.
Back up a system configuration file
Use the following steps to back up your system to a USB Drive:
1. Insert a formatted flash drive in the E2’s front-panel USB port.
2. From the System menu, scroll to the USB Backup/Restore subm enu. Selec t Backup Config.
The USB B ackup Co nfig su bmenu appears. T he navigation cursor appears at the default name for the first backup file.
3. If you wish to change the d efault name of the backup configuration, press SEL.UsetheADJUST knob to change the nam e, as
described in section "Using m enu system", page 48 . Press SEL again w hen you com plete the name change.
4. Scroll to Backup Config and press SEL.
Aconfirmation message appears when the bac kup is com plete.
166
R5905948 E2 12/12/2014
