Filter
Top Products
3 - 28
INSP
ADJ
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
• Loosen the pad pin 2.
• Remove the brake hose holder 3 and
brake caliper 4 from the front fork.
• Remove the pad pin and brake pads 5.
• Connect the transparent hose 6 to the
bleed screw 7 and place the suitable con-
tainer under its end.
• Loosen the bleed screw and push the
brake caliper piston in.
CAUTION:
Do not reuse the drained brake fluid.
• Tighten the bleed screw.
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
• Install the brake pads 8 and pad pin.
N
OTE:
• Install the brake pads with their projections
a into the brake caliper recesses b.
• Temporarily tighten the pad pin at this
point.
• Install the brake hose holder 9 and brake
caliper 0 and tighten the pad pin A.
N
OTE:
Fit the brake hose holder cut c over the
projection d on the front fork and clamp the
brake hose.
T
R
.
.
Bolt (brake caliper):
23 Nm (2.3 m • kg, 17 ft • lb)
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)