Filter
Top Products
6 - 21
– +
ELEC
THROTTLE POSITION SENSOR SYSTEM
3. Inspect:
• Throttle position sensor coil variable
resistance
Check that the resistance in increased as
the throttle grip is moved from the full
close position to the full open position.
Out of specification → Replace.
Tester (+) lead
→
Yellow lead
1
Tester (–) lead
→
Black lead
2
Throttle position sensor
coil variable resistance
Tester
selector
position
Full closed Full opened
k
Ω
×
1
Zero ~ 3 k
Ω
at 20 °C
(68 °F)
4 ~ 6 k
Ω
at 20 °C
(68 °F)
THROTTLE POSITION SENSOR
REPLACEMENT AND ADJUSTMENT
1. Remove:
• Throttle position sensor coupler
• Screw (throttle position sensor) 1
• Throttle position sensor 2
N
OTE:
Loosen the screws (throttle position sensor)
using the T25 bit.
2. Replace:
• Throttle position sensor
3. Install:
• Throttle position sensor 1
• Screw (throttle position sensor) 2
• Throttle position sensor coupler
N
OTE:
• Align the slot a in the throttle position sensor
with the projection b on the carburetor.
• Temporarily tighten the screws (throttle posi-
tion sensor).
1
2
2
1
b
a