Filter
Top Products
2 - 22
SPEC
Î
Fasten the wire harness at its white tape.
Ï
Fasten the wire harness, throttle position sensor
lead (in the wire harness), starter motor lead and
negative battery lead.
Ð
Make sure that the throttle position sensor coupler
does not go outside the chassis.
Ñ
Fasten the throttle position sensor lead.
Ò
Pass the carburetor breather hoses, carburetor
overflow hose and coolant reservoir breather hose
between the connecting rod and cross tube
(frame).
Ó
Fasten the neutral switch lead and oil hose
together with the plastic locking ties and cut off the
tie ends.
Ô
Pass the cylinder head breather hose through the
hose guide.
Õ
Fasten the neutral switch lead.
Ö
Fasten the neutral switch lead and AC magneto
lead.
CABLE ROUTING DIAGRAM