Filter
Top Products
5 - 39
CHAS
FRONT FORK
4. Tighten:
• Pinch bolt (upper bracket) 1
• Pinch bolt (lower bracket) 2
CAUTION:
Tighten the lower bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
• Brake hose holder 1
• Brake caliper 2
• Bolt (brake caliper) 3
N
OTE:
Fit the brake hose holder cut a over the pro-
jection b on the front fork and clamp the brake
hose.
6. Install:
• Brake hose holder 1
• Bolt (brake hose holder) 2
• Protector 3
• Bolt (protector) 4
N
OTE:
When installing the brake hose holder, align
the top a of the brake hose neck with the
brake hose holder bottom b. Then pass the
brake hose 5 in front of the axle boss c and
fit it into the hose groove d so that the brake
hose does not contact the nut (wheel axle).
T
R
.
.
23 Nm (2.3 m · kg, 17 ft · lb)
T
R
.
.
20 Nm (2.0 m · kg, 14 ft · lb)
T
R
.
.
23 Nm (2.3 m · kg, 17 ft · lb)
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)
7. Adjust:
• Rebound damping force
N
OTE:
Turn in the damping adjuster 1 finger-tight
and then turn out to the originally set position.