Filter
Top Products
5 - 42
CHAS
EC5B5000
ASSEMBLY AND INSTALLATION
Handlebar
1. Install:
• Handlebar 1
• Handlebar upper holder 2
• Bolt (handlebar upper holder) 3
N
OTE:
• The handlebar upper holder should be
installed with the punched mark a forward.
• First tighten the bolts on the front side of the
handlebar upper holder, and then tighten the
bolts on the rear side.
2. Install:
• Left grip 1
Apply the adhesive to the handlebar 2.
N
OTE:
• Before applying the adhesive, wipe off
grease or oil on the handlebar surface a
with a lacquer thinner.
• Install the left grip to the handlebar so that
the line b between the two arrow marks
faces straight upward.
T
R
.
.
28 Nm (2.8 m · kg, 20 ft · lb)
3. Install:
• Right grip 1
• Collar 2
Apply the adhesive on the tube guide 3.
N
OTE:
• Before applying the adhesive, wipe off
grease or oil on the tube guide surface a
with a lacquer thinner.
• Install the grip to the tube guide so that the
grip match mark b and tube guide slot c
form the angle as shown.
R
L
90˚
3
1
b
c
HANDLEBAR