Filter
Top Products
A 10 A 11
How to put the transmitter on
1. Attach the transmitter to the elastic strap.
2. Adjust the strap length to fit snugly and
comfortably. Secure the strap around your
chest, just below the chest muscles, and
buckle it.
3. Lift the transmitter off your chest and
moisten the grooved electrode areas
on the back.
4. Check that the wet electrode areas are firmly
against your skin and the Polar logo is in a
central, upright position.
How to start measuring your heart rate
1. Begin with the display that shows
the time of day.
2. Keep the wrist receiver within
1 metre/ 3 feet of your transmitter.
3. Check that you are not near other people
that have heart rate monitors, high voltage
power lines, televisions, mobile phones or
other sources of electromagnetic disturbance.
ties. Do not tighten fully yet. If the cable
ties are too short for your bicycle, put two
of them together to make them longer.
5. There are two spoke magnet options. You
only need to install one of them. One is
installed by rotating it around the spoke
before putting the metal cover on,
another by tightening the screw. The
magnet must be facing the speed sensor.
6. Fine-tune the positioning of both the
magnet and the sensor so that the magnet
passes the sensor closely but does not
touch it. The maximum distance between
the speed sensor and the spoke magnet
should be 5 mm/ 0,2". Once positioned
correctly, tighten the cable ties securely
and cut off any excess cable tie ends.
Your safety is important to us. While
riding your bike, please keep your eyes on
the road to prevent possible accidents and
injury. Check that you can turn the handle
bar normally and cable wires for brakes or
gearing donot catch on the sensor. Check
also that the sensor does not disturb
pedalling or the use of brakes or gearing.
Manual S510 GBR C.pm6 8.3.2001, 12:4410-11