Filter
Top Products
C 47C 46
If you are starting from the Time of day display, press and hold OK.
Exercise information will be stored in an exercise file only when the
stopwatch is running. The ongoing recording is indicated with a graphic
bar that runs continuously on the display.
If your preset exercise requires cycling settings, Set Bike is displayed
for a few seconds. In order to start the exercise set you need to select bike
1 or 2 by pressing and holding the down button until the desired Bike is
displayed.
If there is 00 / - - reading on the display, there is no heart rate reception.
Bring the wrist receiver up to your chest near the transmitter’s Polar logo.
The receiver starts looking for the heart rate signal again.
In the beginning of your exercise, when it has lasted less than 60
minutes, the exercise time is displayed in minutes and seconds. When
you have exercised more than 60 minutes, the exercise time is
displayed in hours and minutes.
You have three optional Exercise modes depending on the selected exercise:
• BasicUse
• Interval Training Set (Int On)
• BasicSet (Int OFF)
Exercise recording mode
Autostart for recording a cycling exercise
If you start from the Time of day display, press OK briefly to enter the
Measure mode. Your exercise recording automatically starts/ pauses as you
start/ stop cycling.
If you want to record cycling information only, start cycling after the heart
rate reading 00 appears on the display. If you want to record both cycling
and heart rate information keep the bike still until your heart rate
appears on the display.
Manual S510 GBR C.pm6 8.3.2001, 12:4446-47