Filter
Top Products
3-1/2"
3/8 X 2"
FIGURE
STEP 1
¯ Insert two 1/2" FLANGE BEARINGS (78) imo the SWIVEL PULLEY BRACKET (30) as in FIGURE
¯
Assemble the SWIVEL PULLEY B1L4CKET (30) to the PRESS BASE (18) using one 1/2 X 3-1/2" BOLT (90) and one 1/2"
HEIGHT LOCK NUT (95). (TIGHTEN THE CONNECTION ENOUGH TO REMOVE THE PLAY, YET ALLOWLNG
SWIVEL BRACKET TO ROTATE FREELY.)
¯
SECURELY assemble one 3-1/2" PULLEY (42) to the SWIVEL PULLEY BRACKET (30) using one 3/8 X 2" BOLT (84),
8" WASHERS (91), and one 3/8" LOCK NUT (92). See FIGURE
¯
SECURELY assemble one 3-1/2" PULLEY (42) to the rear horizontal flat of the PRESS BASE (18) using one 3/8 X 2" BOLT (84),
one 2-3/8" CABLE RETAINING CLIP (45), two 3/8" WASHERS (91), and one 3/8" LOCK NUT (92) as shox~m in FIGURE
(NOTE: 2-3/8" CABLE RETALNING CLIP (45) should face as shown in FIGURE
¯
SECURELY assemble one 4-1/2" PULLEY (43) to the lower horizontal flat of the PRESS BASE (18) using one 3/8 X 2"
(84), two 3/8" WASHERS (91), and one 3/8" LOCK NIJT (92) as shown in FIGURE 1. (NOTE: Make sure there is no
between the two pulleys.)
¯ Attach two 5-1/2 X 2-1/2" NON SKID STRIPS (65) to the LOW ROW/CALF RAISE (2) appro:dmately where shown in FIGURE
SECURELY assemble the LOW ROW/CALF RAISE (2) to the PRESS BASE (18) using t~vo 1/2 X 3" BOLTS (87), two
WASHERS (93), and one 1/2" LOCK NUT (94).
4