Filter
Top Products
FIGURE 33
HEIGHT
1/2 X 3"
X 2-3/4"
1/2 X 4-1/2 ....
STEP 33
¯ SECURELY assemble the PRESS SUPPORT TUBE (2 i) to the PRESS SWIVEL (10) using one 1/2" X 4-1/2" BOL-; (89)
one1/2
’’
LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the PRESS
SUPPORT TUBE to rotate freely).
¯
SECURELY assemble the PRESS BACK SUPPORT (23) to the PRESS SUPPORT TUBE (21) using one 1/2" X Y’ BOLT
and one 1/2" LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing
PRESS BACK SUPPORT to rotate freely).
¯
SECURELY assemble one 1/2" SPRING PIN ASSEIv~LY (52) to the spring pin housing on the PRESS SUPPORT TUNE (21).
(NOTE: Tighten the nut of the SPRENG PIN ASSEMBLY SECURELY:)
SECURELY assemble the BACK PAD (39) to the PRESS BACK SUPPORT (23) using two 3/8 X 2-3/4" BOLTS (85) and two
WASHERS (91). See FIGURE 33.
1/2 l 1/2 [ 1/2 I 1/2 I 1/2
6
29