Filter
Top Products
3/8" HEX NUT ~
FIGURE 32 3/8 X 2-1/2" SOCKET I-~AD CAP SCREW
~TEP 32
¯
SECURELY assemble one 3/8" SPRING PIN (51) to the spring pin housing of the PRESS BACK SUPPORT (23). (NOTE: Tighten
the nut of the SPRING PIN ASSEMBLY SECURELY.)
¯ Assemble one 3-PRONGKNOB (61) the PRESS BACK SUPPORT (23) as shm~a in FIGURE
¯ SECURELY assemble two 3" WttEELS (63) using two BLACK 3/8 X 2-1/2" SOCKET HEAD CAP SCREWS (64) and m’o 3/8" HEX
(108) as shown in DETAIL 32.
¯ SECURELY assemble two wheel assemblies to the PRESS BACK SUPPORT (23) as shown in FIGURE 32.
¯ SECURELY assemble the SEAT PAD (38) to the PRESS SEAT ADJUST (12) using m’o 3/8 X 2-3/4" BOLTS (85) and m’o 3/8" WASHERS
(91). See FIGURE 32.
¯
Pull back the 3/8" SPRING PIN (5 I) on the PRESS BACK SUPPORT (23) and slide the PRESS SEAT ADJUST (t2) into
receiving well. Engage the 3/8" SPRING PIN (51) into one of the adjustment holes.
28