Filter
Top Products
FIGURE 2O
STEP 2O
¯
Insert the PUSH/PULL CABLE through the bottom of the PRESS ARM (27) up to the CONTROL LEVER (60) and hold in place
one E-RING (56) as shown in FIGURE 20.
¯ SECURELY assemble the PUSH/PULL CABLE to the CONTROL LEVER (60) using one 3/8" JOINT CONNECTOR CAP (57), one
INT. TOOTH LOCK WASHER (59), and one 8-32 X 3/16 IN. SCREW (58) as sho~aa in FIGURE
Slide one 4" VINYL SLEEVE (47) over the CONTROL LEVER (60). Then SECURELY assemble the CONTROL LEVER (60) to the
on the PRESS ARM (27) using one 3/8" JOINT CONNECTOR CAP (57), one #8 INT. TOOTH LOCK WAK~IER (59), and one
3/16 IN. SCREW (58) as shown in FIGURE 20.
1/2
l
1/2 ] 1/2
I
1/2
I
1/2 [ 1/2
1 2
3 S 6
19