Filter
Top Products
FIGURE 40
3/8 X 2"
STEP 40
¯
Assemble one 3-1/2" PULLEY (42) around the PEC DEC CABLE (98) and to the PULLEY BRACKET (29) using one 3/8 X 2"
(84), two 3/8" WASHERS (91) and one 3/8" LOCKNUT (92) as shown in FIGURE
STEP 41
Slide the ends of the PEC DEC C.A_BLE (98) into the bushings on the PEC C.MMS (24) as shown on FI GUqLE
FIGURE 41
¯ Lay the PEC DEC CABLE (98) over the pulleys and under the cable retaining clips in the CENTER PULLEY BtL&CKET (26) as shown
N
in FIGURE 41. (NOTE: Securely tighten the pulley connections in the CE~ TER PULLEY BRACKET (26). The cable retaining clips
should be at approximately a 45
~
angle.)
I/2 ] 1/2 I 1/2 I 1/2 I 1/2 I 1/2 1