Filter
Top Products
FIGURE 35
STEP 35
¯ To assemble the D-RING CABLE (102)~foltow the Cable routing as shown and use the following steps:
, Screw one of ~e threaded ends of the D-RING CABLE (102) approximately
~’
into theend of the SELECTOR SHAF~ (7~)of the HEAD
PLATE (72) as shownin FIGURE 35,
, Route the CABLE (102) up and over the two PULLEYS in the TOP BOOM (17) above tile WEIGHT STACK. (Remove pulleys
|~r ease of installation.)
¯ Screw the other threaded end of the D-RING CABLE (102) approximately I into the end of the shaft on the D-RING (7) as sho~n
FIGURE 35,
SECURELY tighten two pulley connections from the previous step,
2