Filter
Top Products
FIGURE 23
STEP 23
¯ Insert two 3/4" FLANGE BEARINGS (76) into the PRESS ARM (27) as shown in FIGURE
¯ Hold the PILES S ARM (27) between the REAR (4) and MIDDLE UPRIGHTS (8) and slide the 3/4 DIA X 11" SHAFT (107)
the MIDDLE UPRIGHT (8), PRESS ’AI~\I (27), and through the collar onthe REARUPRIGHT (4). To SECURE the SHAFT (107)
place, insert two 5/16" SET S CREWS (48) into the collars on the UPRIGHTS and tighten. See FIGURE 23.
¯ Insert two 1/2" FLANGE BEARINGS (78) into the PRESS ARM (27) as shm~a in FIGURE
;TEP 24
1/2 X 3"
¯ Assemble the RECEIVING TUBE (13) to the PRESS ARM (27) using one 1/2 X 3" BOLT (87) and one 1/2" LOW HEIGHT LOCK
(95). (NOTE: Tighten the connection enough to remove play, yet alloMng the PRESS ARM (2) to rotate freely.) See FIGURE
22