Filter
Top Products
[//%- ~’
/
\\
\ <5
>
/
/\
/
/ \
2~IT
LOW
IGHT
/
FIGURE 22
1/2 X 3-1/2"
STEP 22
¯
Attach eight PARAGLIDE STRIPS (62) ENSIDE the end of the RECEIVING TUBE (13) and four P.~RAGLIDE STRIPS (62)
the OUTSIDE of the PRESS ADJUSTMENT TUBE (22) using the following steps:
¯
Thoroughly clean all sufaces where PARAGLIDE STRIPS (62) are to be attached.
¯ Remove the PARAGLIDE STRIPS (62) from the paper backing and firmly apply them to surfaces. (NOTE: Orientate the
strips so they will slide by each other.)
¯
CAREFULLY slide the PRESS ADJUSTiVIENT TUBE (22) into the RECEIVING TUBE (13). (NOTE: Make sure the spring pin
barrel on the RECEIVING TUBE (13) is on the same side as the holes in the PRESS ADJUSTMENT TUBE (22).)
¯ Thread one 3/8 X 1" BUTTON HEAD C.~P SCREW (96) through the slot in the RECEIVING TUBE (13) and into the ADJUSTN~NT
TUBE (22)
¯ Inserttwo 112" FLANGE BEARINGS (78) into the COUNTER LEVER (3) as shmxm in FIGURE
¯
Assemble the PRESS ADJUSTIVlGNT TUBE (22) to the COUNTER LEVER (3) using one 1/2 X 3-1/2" BOLT (90) and one
LOW HEIGHT LOCK NUT (95). (NOTE: Tighten the connection enough to remove play, yet allowing the PRESS
MJSTMENT TUBE (22) to rotate freely.)
21