Filter
Top Products
43
GENERAL
AUTO-CALIBRATION
(DELUXE Only)
DO NOT STAND ON THE BELT WHEN PERFORMING THE AUTO-CALIBRATION!
Auto-calibration is not represented by a Px designation. "Auto" appears in
the center window. When you enter the function, "Auto" begins flashing.
To begin auto-calibration, press START. The treadmill will run through
minimum and maximum speed and maximum incline, this will take three to
five minutes. Let the treadmill perform this complete function before exiting
the Engineering Mode.
Elevation A/D or Elevation in % appears in the left window. PWM value
or Speed appears in the right window. "End" will appear in the center
window when the auto-calibration is complete. When auto-calibration is
complete, it will take about 30 seconds to return to the start-up screen with
P1 showing in the function window.
EXIT USER ENGINEERING MODE
P17 represents exit mode. When you press SELECT to select the function,
the console performs a reboot, returning to program setup.
USER ENGINEERING MODE
(SIMPLE Only)
Your Treadmill offers a User Engineering Mode that can access certain
data and help to troubleshoot your Treadmill. The User Engineering Mode
is designed for you to access functions that will not affect important
Treadmill settings. To access this mode, please hold down the SPEED
DOWN and SELECT buttons while the Treadmill is at the startup mode.
When in User mode, “USEr” will be displayed in the data window. Press
SELECT. Use either set of arrow keys to access the available
functions/data. Press SELECT to select the data/function. To save data,
hold down the SELECT button until the Treadmill beeps. To exit, press STOP.