Filter
Top Products
page 30
COMMERCIAL PRODUCTS DIVISION
TOP DISPLAY WINDOWS
SmartRate: You must enter your age (during the program setup prompts),
and wear a chest strap, while in a program, before the blinking segment in the bar
graph can show the zone that your heart rate is in, either: Weight Loss or Cardio-
vascular.
Weight Loss Zone: Maintaining your heart rate between 55% and 70% of
your maximum aerobic heart rate, helps burn enough calories that, when
continued on a regular basis for 30 minutes or more, provides the greatest
fat-burning results.
Cardiovascular Zone: Maintaining your heart rate between 70% and 85%
of your maximum aerobic heart rate, helps you, when continued on a regular
basis for 30 minutes or more, improve your overall cardiovascular/cardiores-
piratory fitness level.
Important: During a program, you will need to grasp the handrail grips before
the segment begins to blink. If you prefer not to use the touch-sensitive grips
on the handrail, you will need to wear a chest strap. Note that pressing
QUICKSTART disables the SmartRate display feature.
HEART RATE: The heart rate display lets you monitor your heart rate. When a
heart beat is detected, the number appears in the small upper right display (refer
to Diagram 21). If you do not use the touch-sensitive grips on the handrails or you
are not wearing a chest strap, your heart rate will not be detected and no pulse
rate will appear on the display.
UPPER DISPLAY (C956i only)
The Precor banner and program profiles appear in the large center display (LED
matrix). Always start a workout at the Precor banner. During workouts, the program
profile appears in the center display and corresponds to the program you selected.
As you proceed through your workout, your position is indicated by a blinking cell.
CENTER DISPLAY (C956i and C954i)
Prompts appear in this display prior to your workout. You address each prompt
using the numeric or keypad keys. Once you begin a workout, lights appear in the
columns below the window indicating which information is being displayed. You
can highlight a particular feature by pressing the appropriate CHANGE key.
The following describes the information that can appear in the display.
TIME: During your workout, a time (0:00) display appears when you begin working
out. Time appears in minutes and seconds. However, should you exceed 60
minutes (during a single workout), the TIME display converts to hours and minutes.
The TIME display shows what time remains to complete the program. An
exception to this rule exists if you pressed QUICKSTART before specifying a
program duration.