Filter
Top Products
STEP5
Insert two 1/2" FLANGE BEARINGS (67) into
RECEIVING TUBE (13).
Attach RECEIVING TUBE (13) to PRESS ARM LEVER
(9) using one 1/2 X 3-1/2" BOLT (43), and 1/2"
HEIGHT LOCKNUT (50). (NOTE: Securely tighten,
then back nut off 1/4 turn to allow the RECEIVING
TUBE (13) to rotate freely.)
Insert the ADJUSTMENT TUBE (6) into the
RECEIVING TUBE (13) as shown in FIGURE
1/2 X 3-1/2"
FIGURE 5
/
/
LOW
HEIGHT
FIGURE 6
STEP 6
¯ Slide one 3/4 DIA X 11" SHAFT (29) through PRESS ARM (8) & tube on REAP. UPRIGHT (16). See FIGURE
¯ Insert two 1/2" FLANGE BEARINGS (67) into PRESS ARM (8).
1/2 1.
1/2 ]
1/2 [ 1/2 [ 1/2 ] 1/2
6
3
I I I I
7