Filter
Top Products
STEP 15
¯ Securely assemble the WEIGHT STACK SHAFT
(80) to the I-~AD PLATE (81) using one 3/8 X
4" BOLT (46) and one 3/8" WASHER (51).
Insert two GUIDE RODS (33) into the WEIGHT
STACK BASE (3) as shown on FIGURE
(NOTE: Lubricate GUIDE RODS (33) with
silicon or teflon spray available at most hard-
ware stores.)
Slide two WEIGHT STACK SPACERS (34), two
3/4" WASHERS (53), and two WEIGHT STACK
CUSI~ONS (88) - IN Tt]AT ORBER - down
over the GUIDE RODS (33).
Using EXTREME CARE slide all fifteen
WEIGHT PLATES (74) down over the GUIDE
RODS (33) on to the WEIGHT STACK CUSH-
IONS (88). Make sure that the keyholes of the
WEIGHT PLATES (74) are all facing the right
way.
Slide the head plate assembly down over the
GU/DE RODS (33) onto the weight stack.
¯ Insert two CAP PLUGS (89) into the top ends of the
GUIDERODS (33).
¯ Attach the WEIGHT STACK LABELS (94) to the
weight stack. Also insert the WEIGHT STACK
PIN (57) into the first WEIGHT PLATE (74)
the weight stack.
FIGURE 15
over ~olts
FIGURE 16
12
STEP 16
¯ Swing the GUIDE RODS (33) under the TOP
BOOM (7) as shown on FIGURE 16.
Loosely assemble the TOP BOOM (7) to the
REAR UPRIGHT (16) using two 112 X
BOLTS (44), two 1/2" WASHERS (52),
one 1/2" LOCKNUT (49).
Loosely assemble the TOP BOOM (7) to the
FRONT UPRIGHT (11) using two 3/8 X
BOLTS (39), four 3/8" WASHERS (51),
two 3/8" LOCKNUTS (48). Make sure LAT
CABLE (92) is routed OVER top of bolts.